Heidenhain MANUALplus 4110 Manuel d'utilisateur télécharger pdf (Page 109)

100

101

HEIDENHAIN MANUALplus 4110 109

4.4 Roughing Cycles

Plunge longitudinal/transverse

Call the "Roughing, longitudinal/transverse" cycles.

Select "Plunge longitudinal" (see figures at right).

Select "Plunge transverse" (see figures on the

following page).

This cycle machines the area defined by X1/Z1, X2/Z2 and plunging

angle A.

Cycle parameters

 X, Z starting point

 X1, Z1 contour starting point

 X2, Z2 contour end point

 P infeed depth: Maximum infeed depth

 P>0: Machine contour outline.

 P<0: Retract by 1 mm at 45°.

 A plunging angle (default: 0°): Range: 0° <= A < 90°

 W end angle: Oblique cut at contour end—Range: 0° <= W < 90°

 T tool number

 S spindle speed / cutting speed

 F feed per revolution

 The steeper the tool plunges into the material, the

greater the feed rate decrease (max. 50%).

 Pay attention to the dimensions of facing tools (see

“Facing tools” on page 419).

Danger of collision!

If the tool angle and the tool point angle have not been

defined, the tool plunge-cuts at the plunging angle. If the

tool and point angles have been defined, the tool plunge-

cuts at the maximum possible plunging angle. In this case,

the resulting contour will not be completely finished and

may need to be reworked.

1 2 ... 104 105 106 107 108 109 110 111 112 113 114 ... 549 550

Commentaires sur ces manuels

Pas de commentaire

Heidenhain MANUALplus 4110 Manuel d'utilisateur Page 109

Commentaires sur ces manuels

Produits connexes et manuels pour Équipement Heidenhain MANUALplus 4110