Heidenhain IK 5000 Addendum Manuel d'utilisateur télécharger pdf (Page 49)

IK 5000 QUADRA-CHEK 49

1.1 Operation

Perform Profile3D fit analysis

When all the required points have been probed, the points can be fit

to the nominal part model.

When the fit operation is complete, the green probed points will be

shifted to match the part model as closely as possible and form error

whiskers will indicate differences between the probed locations and

the nominal part surfaces.

To perform a fit analysis:

 Click Fit

Points shown before fit calculation Form error whiskers shown after fit operation

To decrease the fit analysis time, well distributed points all

around the part under measure are recommended. In

addition, part alignment and datum can be performed

before commencing the Profile3D measurement or using

the Six Point alignment function in the Profile3D

measurement.

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 99 100

Pas de commentaire

Heidenhain IK 5000 Addendum Manuel d'utilisateur Page 49