Heidenhain IK 5000 Addendum Manuel d'utilisateur télécharger pdf (Page 64)

64 1 Operation

1.1 Operation

The nominal value for the feature parameter along with the selected

ISO tolerance table and index entries are used to determine the low

and high limits to be used when tolerancing the feature. These limits

are calculated through a look-up into the ISO tolerance table. If no ISO

tolerance table entry or ISO tolerance index entry is specified then the

tolerance is considered empty and the tolerance will pass. Also, if the

nominal value for the feature parameter is outside of the range of

nominal values found within the selected tolerance table, then the

tolerance will also pass.

Similar to all tolerances, the ISO tolerance can be added to features

within a program.

The ISO tolerance results can also be viewed in reports when using

the AllTol template.

ISO tolerance results

ISO tolerance added to a feature in a program

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 99 100

Pas de commentaire

Heidenhain IK 5000 Addendum Manuel d'utilisateur Page 64