Heidenhain CNC Pilot 4290 V7.1 Description of B and Y axes Manuel d'utilisateur télécharger pdf (Page 44)

1.9 DIN PLUS: Magazine Tools

Insert magazine tool G714

G714 contains the following functions:

 Move to the tool change position.

 Return the active tool to the magazine.

 Take the programmed tool from the magazine.

 Tilt the B axis to the programmed angle.

 Rotate the tool to the “position angle” (“normal” or “upside down”

attitude).

 Calculate the tool data on the basis of the “orientation O,” the B axis

position and the position angle.

 If programmed, activate the (additive) “compensation D.”

 Set the shoe brake, as programmed.

C=0°

C=180°

0°

V X+Z+Y

V0 X + Z

V1 X, Z

V2 Z, X

V3 X

V4 Z

V5 Y

V6 X+Z+Y

V9 

Cycle G714 is interfaced to the control and the machine by

the machine tool builder. The following description of the

parameters and the operating sequence may therefore

deviate from the functionality provided on your machine.

The machine manual provides more detailed information.

Parameters

ID ID number of the magazine tool.

Press the “Continue” soft key to display the plate list.

Highlight the required tool and confirm your selection.

O Orientation of turning tools. Position of the tool's cutting edge

(see figure).

 Tool positions 1, 3, 5, 7: For roughing, finishing and button

tools (neutral tools are recognized by the tool angle).

 Tool positions 2, 4, 6, 8: For recessing and threading cycles

(a “right-hand” or “left-hand” tool is defined in the tool

data).

B B axis angle. Angle to which the B axis is tilted.

C Offset position angle of turning tools.

 0°: Tool attitude “normal”

 180°: Tool attitude “upside down”

D Additive compensation (1 to 16). Activates the additive

compensation. The additive compensation is deactivated with

the next tool change (see G149).

H Shoe brake

 0: The brake is locked depending on the tool parameter (if

“not driven” the brake is locked; if “driven” the brake is not

locked)

 1: The brake is locked

 2: The brake is not locked

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 118 119

Commentaires sur ces manuels

Pas de commentaire

Heidenhain CNC Pilot 4290 V7.1 Description of B and Y axes Manuel d'utilisateur Page 44

Commentaires sur ces manuels

Produits connexes et manuels pour Équipement Heidenhain CNC Pilot 4290 V7.1 Description of B and Y axes