Heidenhain CNC Pilot 4290 V7.1 Description of B and Y axes Manuel d'utilisateur télécharger pdf (Page 63)

HEIDENHAIN CNC PILOT 4290 63

1.11 DIN PLUS (Y Axis): Milling Cycles

Engrave in XY plane G803

G803 engraves character strings aligned linearly in the YZ plane. The

text to be engraved is entered in the “ID” box as a character string.

Diacritics and special characters that you cannot enter in the DIN

editor can be defined, character by character, in NS. If text is defined

in “ID” and a character is defined in “NS,” the text is engraved before

the character.

G803 starts engraving from the starting position or from the current

position, if no starting position is defined.

Example: If a character string is engraved with several calls, define the

starting position in the first call. All other calls are programmed without

a starting position.

Character table: see the User’s Manual.

Parameters

ID Text. Text to be engraved ()

NS Character number. ASCII code of the character to be

engraved

X Starting diameter (diameter dimension)

Y Starting point

Z Milling floor. Z position, infeed depth during milling.

K Retraction plane. Z position retracted to for positioning.

H Font height. Height of the characters in [mm]

W Position angle of the character string with linear alignment.

Example: 0° = Vertical characters: the characters are aligned

in sequence in positive X direction

E Distance factor. The distance between the characters is

calculated according to the following formula: H / 6 * E

F Available as of software version 625 952-05.

Approach feed factor (feed rate = current feed rate * F)

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 118 119

Pas de commentaire

Heidenhain CNC Pilot 4290 V7.1 Description of B and Y axes Manuel d'utilisateur Page 63